how to clean dyson vacuum?

how to clean dyson vacuum

Do you know that this vacuum cleaner will build up dirt over time? It will lose some of its suction after subsequent use. Moisture and particles of fiber are some of the inevitable substances that make the suction to corrode. With that in mind, you should clean your vacuum regularly. In fact, you should take it as a maintenance schedule. This will make it last for years. Here are some of the supplies you should use in your cleaning process. They will make cleaning easier and enjoyable.

  • Rubbing alcohol.
  • Magic Eraser.
  • Air Compressor.
  • Seam Ripper.
  • Mild detergent.

As long as you follow this procedure, your vacuum will last longer even beyond your expectations.

  1. DISCONNECT AND RINSE THE CANISTER

This is arguably the first step you should never ignore. How do you clean the canister? It all starts by pushing the button between the red pieces. This will ensure that the outer shell has completely been removed from the cyclone. You should consider throwing the debris in the trash. The process will not be complete if you don’t take the canister to your sink. How do you wash the canister? It is very easy. All that you need to do in that case is to wash it with cold water and cloth. What if your canister is extremely dirty? Use mild dish soap.

  1. CLEAR CYCLONE

What is the best way to clean cyclone? Over the years, using an air compressor and blow dryer have proved to be the most effective ways when it comes to cleaning cyclone. How do you prepare? Take your cyclone and go into an open area. Use your tool to remove dirt particles from each hole. A wet cloth will be best to clean the case.

  1. RINSE FILTERS

In most cases, vacuums come with two filters. Therefore you have to take care of both when cleaning your vacuum. You can easily remove both filters from the side by simply popping them out. You should only use cold water when cleaning the filters. Each filter should be dipped in a can of cool water. The number of times mainly depend on how dirty they are.

  1. CLEAN ROLLER

Are you sure that your roller can end up with tangled hair? It might be a hard task cleaning the roller. Disconnect the soleplate. Your vacuum should be upside down when doing this. You can use a pair of scissors or even a seam ripper to remove away any hair that is blocking the roller. At the same time, you can check whether the belt is functioning properly. You can replace it if it is worn out.

  1. WASH HOSE

The first thing you should do is disconnecting it from the wand. How can you do this? Pushing the small red side has proved to be the easiest way to release it. Also, carefully slide the plastic U-bend. The hose will be disconnected from the machine. It is good to know that the hose is as straight as you can get it.

Leave a Reply

Your email address will not be published. Required fields are marked *